Welcome to LEOHAZARD • View topic

Forum rules

Topics/Posts shall only contain the following or they will be deleted

Topic's should only contain "Motherboard/Desktop/Laptop brand and Model"

"Post Specifications"

List which Hazard version you installed including Updates

Motherboard/Desktop/Laptop brand and model, Include revision if applicable
CPU brand and Model
Memory Specifications
GPU/Graphics Card brand and Model
Hard Drive/Partitioning used "i.e:Seagate 250GB SATA, Partition 1 HFS+ (journaled), GUID"

List "kexts" used upon Installation

Post a reply

1 post • Page 1 of 1

Dell D620

Fri Feb 11, 2011 11:35 pm

jrem17

Posts: 1

[Hardware]
Processor: Intel Core 2 Duo T5500 @ 1.66GHz 1.67GHz
RAM: 3GB DDR2 667MHz (2GB in Slot A and 1GB in Slot B)
Graphics Card: nVidia NVS Quadros 110M
HHD: Seagate FreeAgent Go 320GB HDD, formerly an external hdd, now an internal hdd with 250GB for Mac and 70 for Win7 Ultimate
BIOS settings: Multicore Support = Off

Installed the Hazard Snow Leopard 10.6.1- 10.6.2
No other modifications used on initial install. Just the 10.6.1 and 10.6.2 updates.
Updated to 10.6.6 via Software Update
Used Nawcom's 10.6.6 Legacy Kernel and Empire EFI's Legacy Chamelon Bootloader RC2
I had to turn the multicore support off because when its on, Mac runs suupppppeerrrrr slow. You can either turn the Multicore off or type "cpus=1" during efi boot.

If anyone finds out how to permanently get multicore support for the Dell D620, please reply. Other than that...

Works like a charm still get a rare and random kernel panic and the sound is scratchy at times.

FOUR successful installations with the config used above. :)

Post a reply

1 post • Page 1 of 1